1/3/2023 0 Comments Hemera estepsBy default the Sovol SV03 comes with a BL Touch. If you are using the stock BL Touch with a non-stock mount enable the CUSTOM_PROBE line above and enter the offsets below for the new mount. Enabling the ENDER5_PLUS_EZABL or ENDER5_PLUS_NOABL will override the BL Touch setting Hemera esteps plus#By default the Ender 5 Plus comes with a BL Touch. #define CUSTOM_PROBE //For any other probe mount (also used for BL Touch), Enter offsets below #define PETSFANG //This is the RIGHT mounted version #define TM3DAERO_EXTENDED //TM3D Arto Mount for Volcano #define TM3DAERO //TM3D Aero Mount for V6 #define CR10_V6HEAVYDUTY //V6 Heavy Duty Mount #define CR10_VOLCANO //TH3D CR-10 Volcano Mount #define SV01_OEM_MOUNT //Sovol SV01 OEM Mount #define ENDER3_MAX_OEM //Ender 3 MAX Specific OEM Mount #define ENDER2_V6 //Ender 2 Specific V6 Mount #define ENDER2_OEM //Ender 2 Specific OEM Mount #define CR10_OEM //OEM Mount for Creality Machines (Ender3/Ender5/Ender5Plus/CR-10/CR-10S/CR-20) Uncomment the mount you are using for your EZABL to enable EZABL support in the firmware. If you are using the Creality CR-10S Sensor connect to the FIL SENSOR header with the RED wire lined up with the "5V" marking by the header and uncomment the below line. If you are using our EZOut Sensor connect to the FIL SENSOR header with the RED wire lined up with the "5V" marking by the header and uncomment the below line. If you replaced your stock sensor with our EZOut or you added an EZOut enabling the EZOUTV2_ENABLE will override the Creality sensor if your machine had one If your machine came stock with a filament sensor it will be enabled automatically. UNCOMMENT MEANS REMOVING THE // IN FRONT OF A #define XXXXXX LINE. ONLY UNCOMMENT ONE PRINTER AT A TIME!!! IF YOU HAVE MULTIPLE MACHINES FLASH THEM ONE AT A TIME. #define CONFIGURATION_H_VERSION TH3D Configuration = * NO IMPLIED SUPPORT OR WARRANTY IS PROVIDED WITH THIS FIRMWARE AND IS PROVIDED AS-IS Hemera esteps how to#* For directions on how to use this firmware visit and click on your printer/board link
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |